Output power in automatic matching mode for 1 kOhm load resistance of KP-Tg Generator, not less than
10 cm³
Depth of KP-Tp Receiver trace, up to
5 m
Sensitivity of the KP-Tp Receiver at maximum gain, not less than
25 µV
Maximum current consumption of the KP-Tg Generator load
2
Rated supply voltage of Generator KP-Tg
B1/B8 2100/900 MHz thousand m³
Duration of pause between KP-Tg Generator parcels
0.29 -
KP-Tg generator signal sending period
1.92 -
Output power in the automatic matching mode for 50 ohm load resistance of Generator KP-Tg, not less
2 cm³
Maximum power delivered to the line in manual power control mode (with load impedance >100 ohms) Generator K
20 cm³
Effective matching resistance range of KP-Tg Generator
1...1000 yd³
Operating frequencies of the KP-Tg Generator
(50;273.5;420;480;580;720;780) ± 0.5;(2187.5;5500;10000) ± 1 kg
The generator has a
Automatic protection of the electrical circuitry of the appliance against failure in case of severe load resistance surges
In device provided
display of current voltage, load current, signal power and load resistance. If the voltage set at the generator output is not sufficient for high resistance measurements (in case the load resistance is higher than what the generator can measure), the LCD w
KP-Tg has 3 modes of operation
- HF (continuous generation of high frequency signal); - HF-P (generation of high frequency signal with a pause); - LF-HF-P (generation of low and high frequency signal with a pause); In these modes both smooth manual power regulation and automatic power r
The KP-Tg generator is a
Generator with possibility of automatic adjustment of output signal power (auto-alignment with line) and designed for outputting special signals into communication lines for subsequent determination of trace and depth of sintering with the help of receiver
The KP-Tp receiver is structurally designed as a
A portable unit made of aluminium alloy. Inside the unit there is a lithium polymer battery to power the unit
Cable trace detection indication in two ways
by change of level on the indicator and by presence of acoustic signal
Accuracy of KP-Tp Receiver trace determination at the depth of 0.8 m, not more than 0.8 m
15 cm
Sensitivity of the KP-Tp Receiver at minimum gain, not less
75 mV
Bandwidth of KP-Tp Receiver
4...160 kg
Operating frequencies of Receiver KP-Tp
25 kg
Power supply voltage for KP-Tp Receiver
3.7 thousand m³
Current consumption of the KP-Tp Receiver, not more than
130 mA
Overall dimensions of the receiver, not more than
127x60x28 mm
Dimensions of receiving antenna, max.
1040x155x125 mm
Weight of receiver, not more
0.65 m² living area
Weight of receiving antenna, not more
0.45 m² living area
Overall dimensions of the generator, not more
120x60x150 mm
Weight of the generator, not more than
2 m² living area